AIRBAG LIGHT RESET

Sometimes your vehicle can indicate an airbag system fault even if you have not had an accident. We can connect our professional diagnostic tools to your vehicle and read fault/error codes in the system. Then our technicians can fix/replace required components and clear the fault or error codes from your airbag module. Once everything is correctly done the airbags light will go off, and your airbag system will operate properly again.

CRASH DATA REMOVAL

If your vehicle has been in a car accident then the crash data was stored in the airbag module (ECU). We can remove this crash data from your airbag module so you could re-use it as a new. All other data is left intact, therefore, in most cases you will be able to use the airbag module in the original vehicle without recoding. Once all blown components are replaced (airbags, seatbelts, etc.) you can install the airbag module and your airbag system will be fully working again.

Remember that dealerships cannot clear this crash data with conventional diagnostic tools. They can only suggest you to buy a new airbag module, which is very expensive. We can save you money on vehicle repair bill.

SYMPTOMS OF AIRBAG SYSTEM FAULT

If the airbag/SRS warning light is always on or keeps flashing then there is a problem in airbag system. It means that the airbag system will not operate properly if you get into a car accident. With the new NCT changes your vehicle will fail the NCT test if the airbag light doesn’t work in the correct fashion.

The airbag light can come on for many reasons:

• Car accident
• Disconnected or drained car battery
• Attempted jump starting
• Removed fuse
• Corroded wires, connectors, etc.

Please note, that even a slight bump or side impact can store crash data in the airbag module and even if your airbags have not deployed they are now effectively switched off.

AIRBAG MODULE RESETTING SERVICES

To order an airbag module reset by post, please check your part number by choosing your vehicle from the list below.